Customising using Config

39

 

 

You get to source menu 4 by using the menu e key while in source menu 1.

The display will be like this:

cd 1A

The first part of the display tells you which key on the MSR you are setting up. The second part of the display tells you the address. Normally you should leave this set to ‘1A’ unless advised otherwise by your dealer or Meridian technical support.

Use the n and s menu keys to select the second part of the display.

Completing Config

When you are happy with your left/right and master/slave choices, and with your other choices for this speaker:

1.Switch off the DSP5000, using the power switch on the back

2.After a second, switch the DSP5000's power on again

Note Ensure that you have set the two speakers to opposite settings. One must be left, the other right; similarly, one must be the master and the other a slave.

3.Make a note of your choices by marking both speakers on the back in the area provided on the label. Use a pencil so that you can change the marking in future.

Note When customisation is complete, switch the power off, wait for 3 seconds, then switch it on again to restore Normal operation and to save what you have done.

Customising using Setup

For an overview of Setup, see page 31

Features of Setup

Setup provides additional functions:

Choice of wall alignment for the low-frequency response of the speaker

The Store key takes on a ‘Store’ capability

Access to DSP Centre-channel features.

How to use Setup

Note It is not necessary to make any adjustments to the slave for Setup.

1.Switch off the master DSP5000, using the power switch on the back, and wait for 3 seconds

2.While pressing the Store key on the remote control, switch the power on again. The display will momentarily show

SEt

3. Release the Store key

The master will revert to the Standby display and condition. You may now use the speakers normally.

When customisation is complete and you are sure that you have stored the correct tone settings independently for every source you wish to change:

1. Switch the power off and then on again to restore Normal operation

DSP5000 User Guide