TROUBLESHOOTING GUIDE
The following guide is for reference purposes only. Contact a Metrologic representative at
MS7600 SERIES TROUBLESHOOTING GUIDE
SYMPTOMS
POSSIBLE CAUSE(S)
SOLUTION
All Interfaces
| No power is being | Check transformer, outlet and | |
No LEDs, beep | power strip. Make sure the | ||
supplied to the | |||
or motor spin. | cable is plugged into the | ||
scanner. | |||
| scanner. | ||
|
| ||
|
|
| |
| No power is being | Some host systems cannot | |
| supply enough current to power | ||
No LEDs, beep. | supplied to the | MS7600 series scanner. Use | |
| scanner from host. | the power supply included with | |
|
| the scanner. | |
|
|
| |
3 beeps on | Contact a Metrologic | ||
Representative, if the unit will | |||
power up. | failure. | not hold the programmed | |
|
| configuration. | |
|
|
| |
Continuous |
| Contact a Metrologic | |
razz tone on | RAM or ROM failure. | Representative, if the unit will | |
power up. |
| not function. | |
|
|
| |
Razz tone and | VLD failure. | Contact a Metrologic | |
amber LED flash | |||
Representative. | |||
at power up. |
| ||
|
| ||
|
|
| |
Razz tone and |
| Contact a Metrologic | |
both LEDs flash | Scanner motor failure. | ||
Representative. | |||
at power up. |
| ||
|
| ||
|
|
| |
Multiple scans | Same symbol timeout | Adjust same symbol timeout for | |
upon | |||
presentation of | set too short. | a longer time. | |
code. |
|
| |
|
|
| |
|
|
| |
The unit powers | Beeper disabled | Enable beeper | |
up, but does | No volume is selected | Select volume | |
not beep. | No tone is selected. | Select tone. | |
|
|
| |
|
|
|
30
