Via the Euroconnector
Your TV set has 2 Euroconnector sockets. If you want to connect peripherals (e.g. video, decoder, etc.) which have Euroconnectors, to your TV, use SCART - (AV1 / AV2) input.
If an external device is connected via Euro- connector sockets TV is switched to AV mode automatically. In this case if both sockets are connected
Via Ant Input
If you want to connect to your TV, peripherals like video recorders or decoders, but the de- vice you want to connect does not have Euroconnector, you should connect it to the ANT input of your TV set.
If the VCR is connected via antenna input it is suggested to use the Programme 0.
Decoder
Cable TV offers you a wide choice of programmes. Most of them are free, others are to be paid for by the viewer. This means that you will need to subscribe to the broad- casting organisation whose programmes you wish to receive. This organisation will supply you a corresponding decoder unit to allow the programmes to be unscrambled.
For further information ask your dealer. See also the booklet supplied with your decoder.
Connect a decoder with an aerial socket to the TV
• Connect the aerial cable.
Connect a decoder without an aerial socket to the TV
•Connect the decoder to your TV with a eurocable (RCA Jack Cable) to SCART - (AV1 / AV2) (RCA Jack). When your decoder has a Euroconnector / RCA Jack you can obtain better picture quality if you connect a eurocable (RCA Jack Cable) to SCART - (AV1 / AV2) (RCA Jack).
TV and Video Recorder
• Connect the aerial cables.
Better picture quality can be obtained if you also connect a eurocable to SCART - (AV1 / AV2) sockets.
Playback NTSC
Connect NTSC VCR player to one of two Euroconnectors at the back of the TV.
Then, press “AV“ button to select
Search for and store the test signal of the video recorder
•Unplug the aerial cable from the aerial socket “ANT” of your video recorder.
•Switch on your TV and put the video recorder on the test signal. (See the handbook for your video recorder.)
•Search for the test signal of your video re- corder in the same way as you searched for and stored the TV signals. See Install, Search and Store TV channels. Store the test signal under programme number 0.
–Replace the aerial cable in the aerial socket “ANT” of your video recorder once you have stored the test signal.
Camera and Camcorder To connect to (AV-3) input
Connect your camera or camcorder at the back side of your TV.
•Connect your equipment to the TV via VIDEO (yellow), AUDIO R (red) and AUDIO L (white) inputs. You should connect the jacks to the input in the same colour.
Connect the decoder to the video recorder
Some video recorders have a special euroconnector for decoder.
•Connect a eurocable to the euroconnector of y o u r d e c o d e r a n d t o t h e s p e c i a l euroconnector of your video recorder. See also the handbook of your video recorder.
- 57 -
