Metz 20 TK 51 Mute Indicator, No-Signal Detection TV, No-Signal Detection PC, Volume Bar

After the setting time of sleep timer has passed then TV goes automatically to stand- by.

Mute Indicator

It is placed in the upper middle of the screen when enabled, and it stays there until it is disabled.

To cancel mute, there is two alternative; the

first one is pressing to "" button, this vol- ume is set to the preceding value, and the second one is increasing the volume level, thus it starts at the minimum level to in- crease. By decreasing the volume level in mute state, mute will not be ignored, only the volume level will decrease. If mute canceled after decreasing the volume level, the vol- ume will valid with the decreased level.

No-Signal Detection (TV)

If no valid signal detected, it takes 5 minutes for the switching to the Stand-By mode un- less any signal detected or no any Remote

Control command is accessed.

After a Remote Control command (if No-Sig- nal Timer is active) the timer stops and if no signal detected again the timer is initialized to 5 minutes and starts 3 seconds later again to count down.

It is not valid in AV mode.

No-Signal Detection (PC)

If no valid signal detected for 5 minutes sys- tem goes to Stand-By mode. To switch on

the system press “” button.

As the last status feature, system starts from TV or PC, whichever was the status before stand-by or switch-off. Note that SCART in- puts have the precedence on both TV and PC.

Volume Bar

It is displayed in the lower middle of the screen. When a volume command is re-

ceived (pressing “ +” or “ -” by Re- mote Control or Control panel at the top of the TV) and no menu is active, it stays on the screen for 3 seconds, after the last volume command or until another command is re- ceived in between.

AV Modes

By pressing the “AV“ button you can switch your TV to AV modes (except being in Tele- text). Pressing this button will consecutively switch the TV in one of the optional AV modes: AV-1, AV-2, AV-3, S-VIDEO, PC.

In order to quit the AV mode press the “TV”, digit buttons or “P-” or “P+” .

Signal Out Of Range

When the PC input signal is not supported by LCD-TFT TV, a message is displayed like “Signal out of range” and screen is blanked.

PC MODE

Installation

•Power off both Computer and Display before making any connections.

•The monitor comes with a 15-pin PC cable. Connect end of the signal cable to the 15- pin connector￿￿3LQ0LQL'on the￿6XE&RQQHFWRUrear of the Computer.

•Tighten the screws of the Display cable until the connectors are fastened securely (fin- ger-tighten only).

- 52 -