
☞Also see section 5.3 for the display of exposure symbols in the camera’s viewfinder.
4.2Multi-zone flash exposure metering (preflash metering)
☞ For
When the camera’s shutter release is pressed for picture shooting a preflash is fired to measure the subject’s reflection. With the aid of its exposure system and the
The mecablitz must be set to TTL mode.
4.3 ADI flash control (Advanced Distance Integration)
☞For
ADI flash control is a
The mecablitz must be set to TTL mode. ADI flash control is not specifically displayed on the mecablitz. Please refer to the camera manual for the setting procedure of ADI flash control and other details.
4.4 Manual flash mode
☞Various cameras automatically switch the mecablitz to TTL flash mode when in Program “P” or in one of the Subject Program Modes. Manual flash operation is then no longer possible. There is no correct exposure confirmation given on the mecablitz LC display in the manual flash mode!
Set „Av“ aperture priority or the „M“ or „X“ manual modes on the camera. Select the aperture and shutter speed (with „M“) on the camera according to the given photographic situation (see the camera’s operating instructions).
4.4.1 Manual flash mode M with full light output
In this mode the mecablitz always fires uncontrolled flashes at full light out- put. Adaptation to the given photographic situation is only by adjusting the aperture setting on the camera accordingly. The mecablitz LC display will indicate the
Setting procedure for the manual flash mode M
•Turn on the mecablitz by its main switch.
•Continue depressing the „Mode“ key until „M“ flashes on the LC display.
•The setting becomes immediately effective. The LC display is returned to its normal state after approx. 5 sec.
4.4.2 Manual flash mode MLo with partial light output
In this mode the flash unit always fires uncontrolled flashes at 1/8th (Low) of full light output. Adaptation to the photographic situation is by selecting a corresponding aperture setting on the camera. The mecablitz LC display will indicate the
Setting procedure for the manual flash mode MLo
•Turn on the mecablitz by its main switch.
•Continue depressing the „Mode“ key until „MLo“ flashes on the LC display.
•The setting becomes immediately effective. The LC display is returned to its normal state after approx. 5 sec.
58