3. Operations
Command Line Interface
Logging In
Logging in through Telnet requires directing the Telnet client to the configured IP address of the unit.
Logging in through the Console (RS232) port requires the use of a terminal or terminal emulation software configured to support ANSI or VT100 and a supported data rate (300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 BPS) - 8 data
1.Press Enter. The following appears, where x.xx is the firmware version:
AmpMeter PDU Version x.xx Username:
NOTE: Logging in by Telnet will automatically open a session. It is not necessary to press Enter.
2.At the Username: and Password: prompts, enter a valid username and password. And press Enter.
You are given three attempts to enter a valid username and password combination. If all three fail, the session ends.
When you enter a valid username and password, the command prompt (AmpMeter PDU:) appears. If a location identifier was defined, it will be displayed before the AmpMeter PDU: prompt. See Creating a location description on page 26 for more information.
You may enter commands in any combination of uppercase and lowercase. You must enter all command characters correctly; there are no command abbreviations. There are two types of commands: operations and administration. A user must have administrative privileges to use the administration commands. The following tables list and briefly describe each command.
Operations Command Summary
| Command | Description |
|
|
ILoad | Displays the cumulative input load per branch or phase |
|
|
Istat | Displays the status of the infeeds |
|
|
Connect | Connects to a serial port |
|
|
Login | Ends the current session and brings up the Username: prompt |
|
|
Logout | Ends a session |
|
|
Quit | Ends a session |
|
|
List Ports | Lists all accessible serial ports for the current user |
Administrative Command Summary
Add Porttouser | Grants a user access to one or all serial ports |
|
|
Create User | Adds a user account |
|
|
Delete Portfromuser | Removes access to one or all serial ports |
|
|
List User | Displays all accessible outlets/groups/ports for a user |
|
|
List Users | Displays privilege levels for all users |
|
|
Remove User | Deletes a user account |
|
|
Restart | Performs a warm boot |
|
|
Set Envmon Name | Specifies a descriptive field for the integrated Environmental Monitor |
|
|
Set Envmon THS Name | Specifies a descriptive field for a |
Page 18 -