Middleby Marshall PS360, PS570 Conversion Labeling, Natural, 14” W.C./34.9mbar, 36863, Model No

SECTION 3 - SERVICING COMPONENTS

Appendix - Instructions for Service Kit 36863 - Gas Conversion Kit for PS360EWB/WB70 with Midco Burner, Propane to Natural Gas, 1/98

9. CONVERSION LABELING

9.1Remove and discard the round, red “LPG.” label from the front face of the burner plenum.

9.2Apply the round, green “NAT.” label (p/n 22500-0064) to the front face of the burner housing as shown in Figure 7.

9.3Close the machinery compartment access door.

9.4Record the information requested on the silver conversion information label. Figure 8 shows a representation of this label.

9.5Apply the conversion information label to the front of the machinery compartment access door, next to the control panel. See Figure 9.

Figure 7

Yellow “NAT.” label placement

(on burner housing)

Upper oven	Lower oven
label location	label location

Figure 8

Conversion information label

Signature of technician	Date of conversion
performing conversion

NATURAL

THIS APPLIANCE HAS BEEN CONVERTED ON _______________ TO ______________ GAS WITH KIT

36863
NO. ________________ BY _______________ , WHO ACCEPTS THE RESPONSIBILITY FOR
THE CORRECTNESS OF THIS CONVERSION.
		MAIN BURNER ORIFICE SIZE
MODEL NO.				.234”/5.94mm		MANIFOLD PRESSURE
INPUT RATING			MAXIMUM INLET PRESSURES
	175,000 BTU				14” W.C./34.9mbar
Stated on the						Measured value
oven’s data plate						recorded in Step 8.3

Figure 9

Conversion information label placement

PS360EWB placement

PS360WB70 placement

Page 4 of 4 P. Jan. 98 Rev B p/n 36862

138