How to pair two BTX1 unit
The two units supplied in the same BTX1 box, are already paired and ready to use, which mean you don’t need to perform this procedure. The unit are already paired using the Middle button.
If the devices are not part of the same kit, or the units has been purchased sepa- rately, you need to first pair it in order to use it.
To pair the BTX1 to another BTX1 unit
To pair the BTX1 to another BTX1 unit, you must first enter the setup mode:
1.Turn off the unit
2.Press and hold down the middle button about 7 sec., until the Red light is on permanently.
3.Now press the Middle button for 3 seconds. The Blue and Red light will flash.
4.Do the same procedure on the other unit, When successfully paired, each unit will have the Blue light on for one second and than go back to the setup mode (Red light always on).
5.Now the pairing procedure is complete, you just need to exit the setup mode before you can use the units:
6.Double click on the Middle button, the Red light will turn off and the Blue
light will start flashing. You can use now your BTX1.
How to use the Intercom
To use the intercom feature, be sure the both units are turned on and correctly paired together.
Manual activation
Press the Middle button on one of the two units. Communication is enabled and remains active until you press again the middle button. The intercom need some second to activate, you will hear a beep tone when the intercom is open.
Voice activation (VOX)
Simply start talking, after some seconds the communication will be opened and will remain active for the time you are talking. If there is no conversation the intercom will be closed after 40 seconds. If needed you can close the intercom
manually without waiting 40 seconds (just press the middle button).
If needed, you can temporarily disable the VOX feature simply by pressing the Backward button for 7 sec. Two sound beep will advise you when the VOX is di- sabled. To turn the VOX on again, just press the same button, one beep sound will advise you that the VOX is now active (or just turn the unit off and on again).
Adjusting the volume
Your Midland BTX1 uses AGC technology, which automatically adjusts the liste- ning volume in relation to background noises.
However, it is also possible to manually adjust the volume by means of the “Volu- me +” and “Volume
Attention: volume can be adjust only when an audio connection is active.
Attention: the volume buttons (Vol + and Vol
How to pair the BTX1 to Midland BT line units
The BTX1 is compatible with all the BT line unit from Midland. You can pair the BTX1 to a BT2, BT1 or BTX2 unit and the max distance of the intercom is defined from the lower possible.
To pair the BTX1 to another BT line unit, you must first enter the setup mode:
1.Turn off the unit
2.Press and hold down the Middle button about 7 sec., until the Red light is on permanently.
3.Now press long (3 sec) the Middle buttonich button, the Blue and Red light will flash.
4.Follow the procedure on the other unit’s instruction manual (normally you can use the “Volume +” button on all the previous BT line units).
5.When successfully paired, each unit will have the Blue light on for one second and than go back to the setup mode (Red light always on).
Exit the setup mode from both units before you can use them: for BTX1 double click on the Middle button, the Red light will turn off and the Blue light will start flashing. For the other devices of BT line, please refer to their own user manual.
UK
A- Manual activation
Mode | Forward button | Middle button | Rear button |
Intercom |
| Short press: Open/Close intercom to paired | Long press: Toggle on/off wired |
|
| raider |
|
|
| Long press: Change mode |
|
