Installation
Retaining plates
There are three retaining plates A, B and C for fixing the cooker hood to the wall.
First of all drill the holes for attaching the canopy and for fitting retaining plate A.
Before fitting the retaining plate draw a vertical line centrally above the hob on the back wall.
Mark measurement S from the hob surface upwards (see "Appliance dimensions"). This marks the height of the lower rim of the cooker hood.
DA
Drill an 8 mm ø hole on the middle line 18 mm above the height marked S. Insert an S8 plug into the hole.
DA
Drill two 8 mm ø holes, 18 mm above the height marked S and 250 mm right and left of centre. Insert S8 plugs.
Retaining plate A
Drill two 8 mm ø holes, one at S + 100 mm and one at S + 425 mm on the centre line for the retaining plate (see "Appliance dimensions"). Insert S8 plugs.
24
