Plumbing
The water pressure must be between 4.5 and 145 psi (0.3 and 10 bar).
If the water pressure is too low the ma- chine may not take in enough water in the alloted time and the “Water Intake” in- dicator lamp will flash. If this occurs, the water intake time can be increased (see “Problem solving guide”).
If the water pressure is too high, a press- ure reducer must be installed.
Existing plumbing:
Do not, under any circumstances, cut the intake hose. If the hose is cut, the dishwasher will not work, you will have a water leak and you could be injured. If the hose is too long, coil it neatly and place it be- hind the machine.
If the standard 3/8" copper plumbing for a dishwasher already exists with a com- pression fitting and valve as pictured:
Cut the 3/8" copper tubing after the valve.
Install the 3/8" compression to 3/4" MHT (Male Hose Thread) adapter (supplied with the machine), as illus- trated.
Connect the inlet hose to the existing valve/adapter assembly.
Electrical wiring and components should not come into contact with any plumbing fixtures or hoses.
57
