Milan Technology MIL-S8001TG 4-3. QoS Control

4-3. QoS Control

Select QoS Control to access the QoS configuration menu. The system

supports two methods of QoS control – Port-Based and 802.1P/TOS.

From the Main Menu, enter "q" or "Q" to select QoS Control to enable or

disable the Qos function and set the high/low queue priority ratio.

Port-Based Enable: Enter “p” or “P” at the command prompt to enable

Port-Based function.

802.1P/TOS Enable: Enter “e” or “E” at the command prompt to enable

802.1P/TOS function.

Note: Port-Based or 802.1P/TOS function must be anabled prior to

configuring the Priority ID Map function.

QoS Disable: To disable QoS control, enter “d” or “D” at the command

prompt.

Contents

Main MIL-S8001TG User Guide Page Table of Contents Page 1. Introduction Figure 1-1. The MIL-S8001TG switch Features Software Features Package Contents Ethernet Switching Technology Management Methods 2. Hardware Description Front Panel Figure 2-1. Front panel for MIL-S8001TG Page LED Indicators Figure 2-2. LED Indicators Table 2-1. Description of LED Indicators Rear Panel Figure 2-3. The Rear Panel of MIL-S8001TG switch Desktop Installation Attaching Rubber Feet Power On 3. Network Application Small Workgroup Segment Bridge 4. Console Management Connecting a Terminal or PC to the Console Port Page 4-1. Main Menu 4-2. VLAN Mode 4-2-1. 802.1Q VLAN Configuration Page 4-2-1-2. VLAN Configuration 4-2-1-3. Create VLAN Group Page 4-2-1-4. VLAN Status 4-2-2. Port-Based VLAN Configuration 4-2-2-1. Port-Based VLAN Group Configuration 4-3. QoS Control Page Page 4-4. Broadcast Storm Suppression Page 5. Troubleshooting Incorrect connections Faulty or loose cables Non-standard cables Improper Network Topologies Diagnosing LED Indicators Cabling 6. Technical Specifications