Milan Technology MIL-SM801XX

Figure 3-8. After pressing Enter twice, the first secured IP address is set to 199.86.12.46.

Resetting Factory Defaults

You can reset the switch back to factory default settings by using the loaddefault

command. Simply type L 2 at the MIL>_ prompt and press enter.

Note: If you do not type L 2, and only type L, the following option appears:

Usage: loaddefault (0:1:2).

The only correct option is L 2 for the MIL-SM801XX.

Contents

Main Page Page Contents 1. Introduction Features Intelligent Management Features Package Contents Ethernet Switching Technology Management Methods 2. Hardware Description LED Indicators Rear Panel Page 3. Network Configuration Assigning an IP Address to the switch 1. From the Main Menu of the console, select Item 1 by typing in 1 after the 10 2. There are three command options to change the IP Address (the initial Default Page Page Page Page Page Page System Configuration Page Page Page VLAN 21 Page Page Boot Methods 6. Technical Specifications 7. Troubleshooting Incorrect connections 26 n Faulty or loose cables n Non-standard cables Appendix