4-2. Installing Control Box And Adjusting Tilt
1
2
3
4
Tools Needed:
5
6
7
1Weld Control
2Bracket
3Screw
Bracket and screws are installed onto bottom of control at factory.
4 Swivel
Loosen screws. Place control on swivel and slide forward. Tighten screws.
5Tilt Bracket
6Rear Pivot Screw
7Front Screw
Loosen rear pivot screw. Remove front screw. Pivot control down- ward to desired viewing angle. Re- place and tighten front screw. Tight- en pivot screw.
4-3. Installing Boom And Reel Support
4
5
6 
|
| 1 | Swivel Plates |
|
| 2 | Yoke |
|
| Remove hardware from swivel | |
|
| plates and yoke. | |
|
| 3 | Boom |
|
| Set boom into swivel as shown. | |
|
| 4 | Yoke Pin |
3 |
| Install pin through yoke. Install cot- | |
|
| ter pin and spread ends. | |
| 7 | 5 | Bolt |
| Install bolt, washers, and nut. Tight- | ||
|
| ||
|
| en hardware, and back bolt off one | |
|
| half turn. | |
|
| 6 | Locking Knob |
|
| Install locking knob but do not | |
|
| tighten. | |
|
| 7 | Reel Support |
|
| Install reel support. | |
| 2 |
|
|
1 
Tools Needed:
3/8, 3/4 in
