Miller Electric DS-64M Swingarc Setting Sequence Parameters, Sequence Parameters In a Program

SECTION 6 − SETTING SEQUENCE PARAMETERS

6-1. Sequence Parameters In A Program

. See Menu Guide for detailed programming steps.

Trim is arc length. If set to zero, arc length is short. If set to 99, arc length is long.

If time is set to zero in Weld sequence, welding continues until gun trigger is released.

If time is set to zero in any timed sequence except Weld, the sequence is skipped.

			Trim	Volts	Inductance	IPM	Seconds
			0-99	10.0-38.0	0-99%	50-780
1.	Weld	Pulse	X			X	0-100.0
		MIG		X	X	X
2.	Crater	Pulse	X			X	0-5.00
		MIG		X		X
3.	Burnback	Pulse					0-0.25
		MIG		X
4. & 5. Postflow/							0-9.9
Preflow
6.	Run-In
						25-780
6.	Start	Pulse	X			X	0.00-5.00
		MIG		X		X

X = Setting available.

Wire Speed	WFS	Weld WFS
		Start
Preflow	Run-In	Time
Time

Preflow	Run-In Arc	Weld
	Strike
Trigger
Pressed

Weld Time

0-100 sec.

	Crater
WFS	Time
	Burnback
Crater	Time
	Postflow
	Time

Time

	Burnback	Sequence
Crater	Postflow
		End
Trigger
Released

OM-1588 Page 19