Technical specifications, Ddc | Minicom Advanced Systems 3000

DS VISION 3000

17.Technical specifications

		HDTV up to 1080p.
	Resolution	Up to 1920x1440 @ 60Hz.
	Resolution	Depending on the cable length and quality
		Depending on the cable length and quality

	Input/Output video signals	Analog signal red, green, blue 0.7v, p-p 75 Ohm
	Video Signals	Analog signal red, green, blue 0.7v, p-p 75 Ohm
	Video Signals
	Sync	TTL compatible

	Horizontal/Vertical sync polarity	Positive/Negative

	System cable	CATx(5/5e/6) UTP/ FTP 2x4x24 AWG solid wire cable

	Maximum distance	300m / 1,000ft

	Skew compensation	Up to 63 nsec

	DDC	Complies with VESA DDC 2 specifications

	RS232 connection	Full serial = RXD, TXD, DTR, DSR, RTS, CTS

	Serial baud rate	Up to 57,600 bps

		Stereo
		Frequency response: 20 Hz to 20 kHz, +/-1 dB.
		Signal-to-Noise Ratio (SNR): 80 dBA.
	Audio	Total Harmonic Distortion and Noise (THD+N): 0.017%.
	Audio	Stereo crosstalk: -70 dB.
		Stereo crosstalk: -70 dB.
		Input impedance: 10k Ohms.
		Line level output; supports multimedia speakers.
		Maximum I/O levels: 3.1Vp-p (line level).

	Serial	Broadcaster / Transmitter – DCE
	Serial	Receivers - DTE
		Receivers - DTE
	Operating temperature	5°C to 40°C / 41°F to 104°F

	Storage temperature	-40°C to 70°C / -40°F to 158°F

	Warranty	3 years

29

Image 30

Minicom Advanced Systems 3000 manual Technical specifications, Ddc

Contents

DS Vision User Guide Table of Contents Trademarks Technical precautionsWelcome User guide feedback Features Introduction System components Transmitter / BroadcasterReceivers Receiver and Receiver Long side Line Splitters LEDs Tuning Unit DS Vision applications Pre-installation guidelines Transmitter/Broadcaster Line Splitter Long Connecting the cables DS Vision cablesBroadcaster/Transmitter connections Connecting CATx cables DS Vision Broadcaster Correct polarity Center negative and voltage Adjusting the picture qualityConnecting to the power supply Downloading a video table Installing the Service utility DS Vision system managementSaving and exiting Connecting the Serial Download cable Connecting the Serial Download cable Topology Com port Auto-detect TipCheck Update Manual Naming a port Saving a topologySaving a Group Controlling the system Deleting a Group Selecting the ports to command Sending commands Sending/blocking Audio Sending/blocking a Serial commandSending/blocking a bi-directional Serial command To tune from the Transmitter/Broadcaster position Connecting the Serial Download cable to the Receiver Long To tune from the Receiver Long or Line Splitter position Tuning window Red, Green, Blue Remote Tuning RGB signals Remote tuning Gives an overview of the remote tuning Service Remote tuning setup Firmware Display Data Channel DDC hotkey Service SecurityBroadcaster’s Local Serial port Technical specifications DDC Transmitter, Broadcaster 8/16 Regional Offices User Guide