Table of Contents | Minicom Advanced Systems 3000 specification

DS VISION 3000

	Table of Contents
1.	Welcome	2
2.	Introduction	3
3.	Features	3
4.	System components	4
Transmitter / Broadcaster		4
Receivers		4
Line Splitters		6
LEDs		6
Tuning Unit		7
5.	DS Vision applications	7
6.	Pre-installation guidelines	8
7.	The DS Vision cables	9
Connecting the cables		9
Connecting to the power supply		11
8.	Adjusting the picture quality	11
9.	DS Vision system management	12
10.	Installing the Service utility	12
Connecting the Serial Download cable		13
Com port		14
11.	Topology	14
Auto-detect		15
Manual		16
Naming a port		17
Saving a topology		17
Saving a Group		17
Deleting a Group		18
12.	Controlling the system	18
Selecting the ports to command		19
Sending commands		19
13.	Tuning Receivers Long (or Line Splitters) via the Service Utility	20
14.	Remote Tuning	23
15.	Service	26
Firmware		26
Display Data Channel (DDC) hotkey		26
Service		26
Broadcaster’s Local Serial port		26
16.	Security	26
17.	Technical specifications	26

1

Image 2

Minicom Advanced Systems 3000 manual Table of Contents

Contents

DS Vision User Guide Table of Contents Trademarks Technical precautionsWelcome User guide feedback Features Introduction Receivers System componentsTransmitter / Broadcaster Receiver and Receiver Long side Line Splitters LEDs Tuning Unit DS Vision applications Pre-installation guidelines Transmitter/Broadcaster Line Splitter Long Broadcaster/Transmitter connections Connecting the cablesDS Vision cables Connecting CATx cables DS Vision Broadcaster Correct polarity Center negative and voltage Adjusting the picture qualityConnecting to the power supply Downloading a video table Saving and exiting Installing the Service utilityDS Vision system management Connecting the Serial Download cable Connecting the Serial Download cable Topology Com port Check Auto-detectTip Update Manual Saving a Group Naming a portSaving a topology Controlling the system Deleting a Group Selecting the ports to command Sending commands Sending/blocking Audio Sending/blocking a Serial commandSending/blocking a bi-directional Serial command To tune from the Transmitter/Broadcaster position Connecting the Serial Download cable to the Receiver Long To tune from the Receiver Long or Line Splitter position Tuning window Red, Green, Blue Remote Tuning RGB signals Remote tuning Gives an overview of the remote tuning Service Remote tuning setup Firmware Display Data Channel DDC hotkey Broadcaster’s Local Serial port ServiceSecurity Technical specifications DDC Transmitter, Broadcaster 8/16 Regional Offices User Guide