(3) Initial setting of modem
For the modem to be installed at the local side (MN Converter side), initial setting should be applied
before connecting remotely. To apply the initial setting of the modem, click 
on the remote setting screen.
The Connection Modem Initial Setting Screen will appear. A modem that is already initialized does not have to be
The explanation of the operation only is described here. For the detail of the setting content, see Installation
(a)Explanation of screen
and the modem will be set up according to the contents selected at the selection box.
(AT commands are sent to the modem.)
Check if transfer with the modem is normal at the Transfer with Modem Status Screen.
-Click on 
to initialize another modem. Send the initialize command and register the transfer contents for the modem at the AT Command Transmit Screen. [Refer to (b)]
-Click on 
to delete the selected modem settings from the registered settings. When the
number of registrations limit is exceeded, delete the unwanted contents. [Refer to (b)]
-Click on 
to return to the Connection Setting Screen.
(b)Perform new modem setup.
-Enter the command (you want to set) you want to
send
to the modem at the AT command input text.
Then click onto send the entered AT command to the modem. The response from the modem will appear below the entered AT command. Check the contents.
-After transmission to the modem is complete, click
on 
. The contents sent to the modem will be registered as an initialize file. (Registered in the setup file list of the Connection Modem Initial Setting
Screen.) At this time, do not forget to enter the registration name. Up to ten items can be registered. If ten items are already registered, new items cannot be registered. Delete unwanted items using the Connection Modem Initial Setting Screen.
-Click on 
to return to the Connection Modem Initial Setting Screen.
11
