U s i n g F l o p p y D i s k , C D - R O M & T a p e D r i v e s
Using an FTD Travan tape drive
The FTD Travan tape drive uses the on-board diskette/floppy disk interface and so does not require an additional drive controller card like most other tape drives.
1 2
1drive activity indicator (green)
2flip-up door
The drive is designed for TR-1 or equivalent minicartridges (750 ft, 400 Mbytes). This nominal capacity can typically be doubled to 800 Mbytes by software data compression. The software required to control the tape drive depends on your operating environment; ask your supplier for details.
Note
The drive can also accept QIC-80 Wide cartridges (400 ft, 208 Mbytes) and long-length QIC-80 cartridges (307.5 ft, 124 Mbytes).
Inserting a cartridge
1.Remove the cartridge from its plastic holder.
2.Hold the cartridge so that the metal plate faces downwards, as shown below. Slide the cartridge into the drive slot until you feel a slight resistance.
APRICOT 340 OWNER’S HANDBOOK 4/5