U p g r a d i n g
11.Slide the hard disk drive into the bay from the front, with the drive’s circuit board facing upwards and its power and signal connectors away from you.
12.Line up the mounting holes on the drive with those in the bay, insert the securing screws and tighten them until they are finger tight. Fit pair A first, then pair B.
A
B
If you are installing a hard disk drive in a system that previously had only a diskette drive there will be two sets of mounting holes available in the bay. Install the new hard disk drive in the position closest to the diskette drive.
Caution
Use only the mounting screws supplied with the drive. If you use any other screws you risk damaging the drive. If there is a drive in the bay already, try to ensure that the new drive does not touch it.
13.Turn the bay upright and replace it in the system unit. Align the flanges on the bay with the lugs in the base of the system unit, then slide the drive bay forwards slightly.
APRICOT 340 OWNER’S HANDBOOK 7/23