U p g r a d i n g

6.Unplug the power and signal cables from the rear of the diskette drive.

7.If one hard disk is already fitted, unplug its power and signal cables from the rear of the drive.

8.The hard disk drive bay is secured by two screws and held by two lugs in the base of the system unit. Identify the screws and lugs from the following illustration.

OVERD

RIV

E

9.Remove the screws. Slide the drive bay backwards and lift it out of the system unit. Turn the drive bay upside-down and rest it on a flat surface with the front of the diskette drive towards you.

10.Ensure that the drive you are adding is properly configured as

either master or slave.

7/22 APRICOT 340 OWNER’S HANDBOOK