![](/images/new-backgrounds/1127108/12710843x1.webp)
Connections
Connecting to CCTV camera, monitor, and sensor
Dome camera
Camera #1
Up to 16 cameras
To CAMERA IN 1 connector
Clamp the power cord using the supplied cable clamping band in order to prevent the accidental removal of the cable.
(See page 20.)
To OUTPUT A VIDEO or
OUTPUT A S(Y/C) connector
Clamp the USB cable using the supplied cable clamping band in order to prevent the accidental removal of the cable.
(See page 20.)
Monitor
To VIDEO IN or
S(Y/C) IN connector
One of either codes should be connected.
To VIDEO IN connector
To OUTPUT B connector
Monitor
To ALARM IN terminal | To GND |
|
corresponding to the | terminal |
|
camera #. |
|
|
Power code |
|
|
Sensor #1 | PC |
| To LAN | |
To SERIAL | PC | |
BUS | ||
|
External recording device
Up to 7 units can be mounted at the same time.
PTZ control connectors
Mouse
RS422 type
dome camera
Processing the connecting line
Connection on the ALARM IN terminals, the I/O terminals, and RS485/RS422 Compatible power lines ø0.32 - ø0.65 mm (AWG 28 - 22)
Cut the designated area from the electric wire’s outer covering (vinyl portion).
RS232C type dome camera (camera controller)
You can connect various devices to control this unit from them, or to control them from this unit. However, depending on the operational condition of this unit, the operational speed of this unit may become slower or control of the external device may be delayed.
18