Mitsubishi Electronics DX-TL4516U instruction manual Setup Wizard

Setup Wizard

Setup Wizard

The setup wizard is displayed when the unit is turned on for the first time. The Wizard enables a quick setup.

Only when the unit is turned on for the first time, the setup

wizard screen is displayed automatically. It is not dis- played next time the unit is turned on.

Turn on the power for the first time

step 2

Select whether or not to use Setup Wizard

step 3

D Language Selection

step 4

DTime Date Adjust

A+C Day Light Saving

step 5-1

DHDD Connection

step 5-2

2HDD Selection

1Detailed setting (Internal HDD)

2Detailed setting (serial bus HDD)

step 6-1

DHDD Configuration

step 6-2

2Partition setting

step 7

DSelect whether or not to set normal recording conditions

step 8

DRecording Setup (step 1 Camera check)

step 9

Recording Setup

D(step 2 Define regular recording cycle)

step 10

C	Recording Setup
	(step 3 Confirm recording settings for each camera)

5Camera settings overview

step 11

DFinish

step1. After connecting the cameras and the monitors, turn on the MAIN switch on the rear panel and wait until the ACCESS indicator is turned off, then press the POWER button on the front panel.

• The <Setup Wizard> screen appears.

The POWER button does not operate while the ACCESS indicator is flashing. Press the POWER button after the indicator is turned off and “POWER OFF” is displayed on the LCD display on the front panel.

step2. Select whether or not to use the setup wizard.

•Select “Go” when you want to use the setup wizard. If not, select “Quit.” When selecting “Quit,” the clock starts running from the initial setting.

Beware that the menu screen cannot be exited while set-

ting the setup wizard. Furthermore some menu screens which have already been set are not displayed again.

step3. (When selecting “Go”) Select the desired language.

•The <Language Selection> screen appears. The language of the menu can be selected in this screen.

•Select the desired language and then select “Execute” when you have changed the setting. The unit restarts when selecting “Execute.”

•Select “Next” when the language setting does not have to be changed.

step4. Set the present time and daylight saving setting. ( page 58)

•Select “Next” when the setting is completed. The clock start running when exiting this screen.

step5-1.Set the connected HDD.

•When you use only the internal HDD, select “Internal” and then select “Next.”

•When you use the external HDDs, select “Int + Ext” and then select “Setting” to set the detailed setting for each HDD.

step5-2.(When selecting “Setting”)

Make the detailed setting for internal and serial bus HDDs.

•In the detailed setting screen, select “Main” and “Copy2” to use the selected HDD as the main device and copy 2 device respectively. Select “Free” when the selected HDD is not used as the main or the copy 2 device.

•When the setting is completed, return to the screen of step 5-1 and then select “Next.”

step6-1.Set the HDD configuration.

Normal: Does not set partition.

Partition: Sets an independent partition for alarm recording within the total HDD memory. When selecting “Partition,” set the partition capacity.

•Select “Next” when selecting “Normal.”

•Select “Setting” to set the partition capacity when selecting “Partition.”

26