Mitsubishi Electronics HC6000 Accessory air-filter unit, Attaching the accessory air-filter unit

Accessory air-filter unit

An accessory air-filter unit is supplied with this projector in order to keep dust out more effectively. When using the projector in a dusty place, replace the air filter (filter cover) attached at the factory with this accessory air-filter unit.

Attaching the accessory air-filter unit

Before installing this accessory air-filter unit to the projector, be sure to unplug the projector from the outlet.

•Remove the air-filter (filter cover) attached at the factory first. (See page 38.)

1.Attach the accessory air-filter unit to the projector.

•Insert the tabs on the top of the accessory air-filter unit in the projector, and then push the accessory air-filter unit in the direction of the arrow.

•Don’t use any other accessory air-filter units than that designed for this projector.

Accessory air-filter unit

Cleaning the air-filter

Warning:

Never use flammable air duster or other materials when cleaning the accessory air-filter unit. Flammable substances may ignite causing fire or breakdown when the lamp is illuminated.

Before cleaning, be sure to turn off the main power switch and unplug the projector from the outlet.

•Clean the air-filter frequently (at least once a month). When dust accumulates on the filter at the air inlet, the temperature inside the projector may rise abnormally high, causing damage to the internal parts and reducing the lifetime of the panel.

•In case of any abnormality including an abnormal rise of the inside

temperature, the projector may automatically turn off and go into the standby mode where the light source lamp is turned off in order to protect its internal parts.

1.Remove the accessory air-filter unit from the projector.

•Pull the accessory air-filter unit in the direction of the arrow while pushing up the tabs on the bottom of the accessory air- filter unit.

2.Remove the air-filter from the cover.

(1) Remove the holder by pushing the tab of the holder on the air- filter in the direction of the arrow.

(2) Remove the air-filter (white), spacer, and air-filter (gray).

3.Clean dirt and dust adhering to the air-filter using a vacuum.

•For the air-filter (white)

If stubborn stains persist, wash the air-filter with water and dry well in the shade.

•For the air-filter (gray)

If stubborn stains persist, wash the air-filter with diluted detergent, rinse with water, and dry well.

4.Attach the air-filter to the cover.

(1) Attach the air-filter (gray), spacer, and air-filter (white) to the cover, aligning their notches with that of the cover.

(2) Insert the right tab of the holder to the cover and push the left tab in the direction of the arrow to attach the cover.

Accessory air-filter unit

Holder

Cover

Air-filter (gray)

Spacer

Air-filter (white)

5. Attach the accessory air-filter unit to the projector. Holder

•Insert the tabs on the top of the accessory air-filter unit in the projector, and then push the accessory air-filter unit in the

direction of the arrow.

Accessory air-filter unit

EN-39