Mitsubishi Electronics HC6000 user manual Preparing your projector, Checking accessories

Models: HC6000

1 47
Download 47 pages 17.14 Kb
Page 6
Image 6
Preparing your projector

Preparing your projector

Checking accessories

The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in the package.

„ Cables

Mini D-SUB

15-pin

Mini D-SUB

15-pin

RGB cable for PC

(246C521-10)

D-SUB

9-pin

D-SUB

9-pin

RS-232C cable

(246C548-10)

Used for projector control by computer.

„Power supply parts

Power cord (two)

(246C483-10, 246C383-20)

„Remote control parts

Remote control

R6P (Size-AA)

(290P158-10)

battery (two)

„Filter parts

Accessory air-filter unit

(761B504-10)

„Others

Lens cap (attached to the projector)

Lamp replacement tray (857C106-10)

User Manual/Quick Start up (English only) (871D494-50)

CD-ROM (with User Manual) (919C154-50)

Safety Manual/Quick Start up (871D489-50)

Important:

• The attached power cords are to be used exclusively for this product. Never use them for other products.

Inserting the batteries into the remote control

1

 

1.

Remove the back lid of the remote control.

3

2.

Check the polarity (+), (-) of the batteries, and set them

 

 

 

correctly, inserting their (-) side first.

 

 

 

• If the battery is inserted from the (+) side first, inserting

 

 

 

the (-) side is difficult because the coil spring end hits

 

2

 

on the battery side. If the battery is forced in this way,

 

 

the outer label of the battery may get ripped and it may

 

 

 

cause a short-circuit and heating.

 

 

3.

Attach the back lid.

 

 

Important:

 

 

Use two size-AA batteries (R6P).

 

 

Replace the two batteries with new ones when the remote

 

 

 

control is slow to respond.

Caution:

Use of a battery of wrong type may cause explosion.

Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

Dispose of used batteries according to your local regulations.

Batteries may explode if misused. Do not recharge, disassemble, or throw them in fire.

Be sure to handle the batteries according to the instructions.

Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

Keep batteries out of reach of children and pets.

Remove the batteries, if the remote control is not used for a long time.

Do not combine a new battery with an old one.

If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

EN-6

Page 6
Image 6
Mitsubishi Electronics HC6000 user manual Preparing your projector, Checking accessories