Mitsubishi Electronics PD-4225S manual External A/V Source Setup, DVD Setup, DTV Setup

NOTE: Not all cables shown are included with the TV. They are available at most consumer electronics stores.

External A/V Source Setup

How to connect

Connect the audio and video cables from the external equipment's output jacks to the TV input jacks, as shown in the figure.

When connecting the TV to external equipment, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red).

How to use

1. Use the DEVICE button on the remote control to select Video (Rear).

2. Operate the corresponding external equipment. Refer to external equipment operating guide.

DVD Setup

How to connect

(FACTORY INSTALLED)

DTV Setup

- To watch digitally broadcasted programs, pur- chase and connect a digital set-top box.

-This TV supports HDCP (High-bandwidth Digital Content Protection) protocol for DTV (480p,720p,1080i) modes.

1.Connect the DVD video outputs to the COMPONENT INPUT jacks (Y, PB, PR) and connect the DVD audio outputs to the AUDIO INPUT jacks.

How to use

1.Turn on the DVD player, insert a DVD.

2.Use the DEVICE button on the remote control to select Component.

3.Refer to the DVD player's manual for operating instructions.

•Component Input ports

To get better picture quality, connect a DVD player to the com- ponent input ports as shown below.

The TV Component Ports	Y		PB		PR
DVD Player Video	Y	Pb			Pr
	Y	B-Y		R-Y
Output Ports	Y	Cb			Cr
	Y		PB		PR

(FACTORY INSTALLED)

How to connect

1.Use the TV’s COMPONENT (Y, PB, PR) INPUT, RGB, or MONITORLINK/DVI jack for video con- nections, depending on your set-top box con- nector. Then, make the corresponding audio connections.

How to use

1.Turn on the digital set-top box. (Refer to the owner’s manual for the digital set-top box.)

2.Use the DEVICE button on the remote control to select Component, RGB or MonitorLink.

or

Digital Set-top box

or

Owner’s Manual 25