96Appendices

Appendix D: Troubleshooting, continued

Reset Name

 

When to Use

 

How to Use

 

Resulting Action

Parental Lock

 

To change your Parental

 

This information is listed on the cutout page in

 

Allows a new code to be

 

 

 

Pass Code

 

Lock Pass Code

 

Appendix A. Please refer to that page.

 

established.

 

 

 

 

 

 

 

 

Front-Panel Lock

 

To re-enable the front-

 

When Energy Mode is set to Fast

 

Allows the front panel to be

Release

 

panel controls after

 

 

Power On, press and hold the MENU

 

unlocked if the remote control is

 

 

activation of the Front-

 

 

button on the front panel for over eight

 

misplaced.

 

 

Panel Lock

 

 

seconds.

 

 

 

 

 

 

When Energy Mode is set to Low

 

 

 

 

 

 

 

Power, press POWER on the front panel to

 

 

 

 

 

 

 

turn on the TV. Press and hold the MENU

 

 

 

 

 

 

 

button on the front panel for over eight

 

 

 

 

 

 

 

seconds.

 

 

 

 

 

 

 

 

 

System Reset

 

If the TV does not turn on

 

Press the SYSTEM RESET button on the front

 

The TV will turn off and the green LED

 

 

or off, does not respond

 

panel with a pointed object such as the

 

will flash quickly for about one minute.

 

 

to the remote control or

 

point of pencil or end tip of a paperclip.

 

When the green LED stops flashing,

 

 

front panel buttons, or

 

 

 

 

you may turn on the TV. The changes

 

 

has audio but no video.

 

 

 

 

you made most recently, before using

 

 

 

 

 

 

 

SYSTEM RESET, may be lost. Changes

 

 

 

 

 

 

 

you made previously, however, are

 

 

 

 

 

 

 

not lost.

 

 

 

 

 

 

 

 

TV Reset

 

To reset all consumer-

 

1.

While viewing the TV, press MENU to

 

The TV will start the initialization

IMPORTANT:

 

accessible settings

 

 

display the TV Main menu.

 

process. The TV will then turn off

Use this reset

 

and all memories to the

 

2.

With the Main menu displayed, press

 

and the front green LED will start

only if all other

 

original factory defaults.

 

 

flashing. When the LED stops

 

 

 

number keys 1 2 3 to display the

 

resets have been

 

 

 

 

 

flashing, you can turn the TV on

 

CAUTION: All owner-

 

 

Reset Menu.

 

unsuccessful.

 

 

 

 

again. The Parental Lock Access

 

 

 

 

 

 

performed setups and

 

3.

READ THE ON SCREEN WARNING

 

 

 

 

 

code will remain unaffected, but

 

 

adjustments will be

 

 

AND INSTRUCTIONS.

 

 

 

 

 

 

all other memories and settings

 

 

erased.

 

 

• If you do not wish to use this reset,

 

 

 

 

 

 

outlined in this Owner’s Guide will

 

 

 

 

 

press EXIT or MENU to back out.

 

 

 

 

 

 

 

need to be set again.

 

 

 

 

 

• If you do wish to use the reset,

 

 

 

 

 

 

 

 

 

 

 

 

 

press ENTER to erase all memories

 

 

 

 

 

 

 

and settings.

 

 

 

 

 

 

 

 

 

 

Service and Support

Service

If you are unable to correct a problem with your TV, consult your Mitsubishi dealer or Mitsubishi Consumer Relations at (800) 332-2119.

DO NOT adjust any controls other than those described in this Owner’s Guide.

DO NOT remove the protective back cover of your TV.

Support

To order replacement or additional remote controls, lamp cartridges, or Owner’s Guides, visit our website at www.mitsuparts.com or call (800) 553-7278.

For questions:

Call Consumer Relations at 800-332-2119. E-mail: MDEAservice@mdea.com Website: www.mitsubishi-tv.com

Important

All lamps replaced under warranty must be returned to Mitsubishi where they will be inspected for defect verification.

Page 96
Image 96
Mitsubishi Electronics WD-52631 manual Service and Support