Mitsubishi Electronics WD-52631 manual VHF Leads, For an antenna with flat twin leads

Chapter 2. TV Connections 27

Antenna with a Single Lead				Antennas with Separate UHF and
A. For an antenna with flat twin leads				VHF Leads
A 300-ohm-to-75-ohm transformer is required. This is not				Required: UHF/VHF combiner
included with the TV, but is available at most electronics
				This is not included with the TV, but is available at most
stores.
				electronics stores.
A1. For an antenna with flat twin leads, connect the 300-
				1. Connect the UHF and VHF antenna leads to the UHF/
ohm twin leads to the 300-ohm-to-75-ohm trans-
				VHF combiner.
former.
				2. Push the combiner onto ANT 1/MAIN on the TV
A2. Push the 75-ohm side of the transformer onto ANT 1
				back panel.
on the TV back panel.
B. For cable or antenna with coaxial lead						�����
Connect the coaxial lead directly to ANT 1 on the TV				������������ �������������		����������� ����������� �
							�
back panel.				��������������� ����������������
		�	�
	��������		�����
		����������� ����������� ��������
	�����
			����������	���������������
						����������������������������
				��������
				�������
				��������
						�������	���������
						�����
		�������������������������������������				���
��������	������			�����������		�������������
���������	��������	�������	���������
����	�����	���		�������
		�����
				��������		��
				���
	��			���		�������������
				����	����
		���		����	����
	���			��
	�����������������
	���������			Figure 8. Connecting separate UHF and VHF Antennas
	��������������������
Figure 7. Connecting a Single Antenna

Mitsubishi strongly recommends you avoid using antennas with flat twin leads. Flat twin lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.