Mitsubishi Electronics WD-Y57aa Antenna with a Single Lead, For an antenna with flat twin leads

Chapter 2. TV Connections 23

Antenna with a Single Lead

A. For an antenna with flat twin leads

A300-ohm-to-75-ohm transformer is required. This is not included with the TV, but is available at most electronics stores.

A1. For an antenna with flat twin leads, connect the 300-ohm twin leads to the 300-ohm-to-75-ohm trans- former.

A2. Push the 75-ohm side of the transformer onto ANT 1 on the TV back panel.

B.For cable or antenna with coaxial lead

Connect the coaxial lead directly to ANT 1 on the TV back panel.

				
	57 #BDL			*/165
			"/5  ."*/
	1BOFM	"/5   "69			64& 8*5)
					$BCMF$"3%™
			R
		TM
			$BCMF$"3%™ 64& 8*5) "/5  $"3% 501
0IN	0IN
'MBU5XJO	$PBYJBM	%*(*5"-		*&&& 
-FBE	$BCMF	"6%*0
		065
	#
		"
	"
	0QUJPOBM 0IN
	UP0IN
.BUDIJOH 5SBOTGPSNFS

Figure 4. Connecting a Single Antenna

Antennas with Separate UHF and VHF Leads

Required: UHF/VHF combiner

This is not included with the TV, but is available at most electronics stores.

1.Connect the UHF and VHF antenna leads to the UHF/ VHF combiner.

2.Push the combiner onto ANT 1/MAIN on the TV back panel.

					
					*/165
			"/5   "69	"/5  .."*/6
7)' "OUFOOB	6)' "OUFOOB				$
$IBOOFMT 	$IBOOFMT 
'MBU 5XJO -FBE				R
			TM
				$BCMF$"3%™ 64& 8*5) "/5 
&YUFSOBM
"OUFOOB
PS $BCMF
			%*(*5"-		*&&& 
			"6%*0
			065
	0INUP		57 CBDL QBOFM
	0IN
	$PNCJOFS		
	6)'
	7)'		5P "/5 ."*/
	#BDL	4JEF
	7JFX	7JFX
	

Figure 5. Connecting separate UHF and VHF Antennas

Mitsubishi strongly recommends you avoid using antennas with flat twin leads. Flat twin lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.