Mitsubishi Electronics WD-Y57aa manual When You First Power On the TV, Using the TV’s Setup Menu

36Chapter 3. TV Setup

When You First Power On the TV

Choosing a Language for Menus

When you power on the TV for the first time, you can select either English or Spanish for all menus. You can later change the language through the Setup menu.

Figure 1. The Welcome screen lets you change the menu language when you first power on the TV.

TV Guide On Screen Setup Reminder

If you do not set up the TV Guide On Screen system when you first turn on the TV, a reminder screen will appear the next six times you turn on the TV (see figure 2). To set up the TV Guide On Screen system, see “Additional Setup with the NetCommand Menu” later in this chapter.

Figure 2. TV Guide On Screen setup reminder

Using the TV’s Setup Menu

Use the Setup menu for basic TV setup options. To display the Setup menu, press MENU to open the Main menu. With the Setup icon highlighted, press ENTER.

Figure 3. Open the Setup menu from the Main menu.

Language (Setup Menu)

Choose to display on-screen menus in either English or Spanish (Español).

To listen to audio in other languages (when available), see chapter 5, “TV Menu Settings, and the “Audio Settings” section. Then refer to either “SAP” (analog signal) or “Language” (digital signal).

Memorize Channels (Setup Menu)

For ANT 1/MAIN and ANT 2/AUX

The memorization process performs two scans of all pos- sible channels on the selected ANT input. Analog chan- nels are scanned first, then the process is repeated for digital channels. Channel memorization may take up to 15 minutes to complete.

To start channel memorization

1.Highlight an input selection based on your connections:

Input		Condition
Ant 1	Air,	When connected to an indoor/outdoor
Ant 2	Air	antenna
Ant 1	Cable,	When connected to direct cable (no cable
Ant 2	Cable	box)

2. Press ENTER to start automatic channel memorization.

To stop channel memorization before completion Press CANCEL.

Channels memorized before you pressed CANCEL are retained in memory. If you restart memorization, all previ- ously memorized channels for the selected antenna input are erased and the process restarts.

After channel memorization, press CH  /to tune to memorized channels. Select the Channel menu for further channel editing, such as adding and deleting channels from memory, naming channels, and saving favorite chan- nels in custom memory banks.