Lexmark W850 Configuration change, some held jobs were not restored, Too many disks installed

Troubleshooting 150

57 Configuration change, some held jobs were not restored

Since the time the jobs were stored on the printer hard disk, something changed in the printer to invalidate the held jobs. Possible changes include:

•The printer firmware was updated.

•Paper input, output, or duplex options needed for the print job were removed.

•The print job was created using data from a device in the USB port, and the device is no longer in the port.

•The printer hard disk contains jobs that were stored while installed in a different printer model.

Press the up or down arrow button until Continue appears, and then press to clear the message.

58 Too many disks installed

1Turn the printer off.

2Unplug the power cord from the wall outlet.

3Remove the extra disks.

4Connect the power cord to a properly grounded outlet.

5Turn the printer back on.

58 Too many flash options installed

Too many optional flash memory cards or too many optional firmware cards are installed on the printer. Try one or more of the following:

•Press the up or down arrow button until Continue appears, and then press to clear the message and continue printing.

•Remove extra flash options:

1Turn the printer off.

2Unplug the power cord from the wall outlet.

3Remove extra flash options.

4Connect the power cord to a properly grounded outlet.

5Turn the printer back on.

61 Defective disk

Install a different hard disk before performing any operations that require a hard disk.