Monessen Hearth CSDV20DNV PLACE CSDV40 LOGS IN FIREBOX, Place Rock Wool Ember Material In Firebox

CSDV Series Direct Vent Gas Stove LOG PLACEMENT

PLACE CSDV40 LOGS IN FIREBOX

Figure 40

1.Carefully remove logs from wrapping.

2.Open front door of firebox.

3.Place rear log (#1) on rear log pins.

4.Place left base log (#2) on the two pins against left side of firebox.

5.Place right base log (#3) on the two pins against right side of firebox.

6.Place top left log (#4) on left base log. Line up the notch in the bottom of the top log with the locator pins on the bottom log.

7.Place top right log (#5) on right base log. Line up the notch in the bottom of the top log with the locator pins on the bottom log.

8.Rest one end top mid log (#6) on left base log and the other on front burner.

PLACE ROCK WOOL (EMBER MATERIAL) IN FIREBOX

Break up rock wool (ember material) into dime-sized pieces. Fluff up rock wool. Place rock wool evenly across both burner surfaces. Do not block any areas around the perimeter of the burner, as these are the areas that supply the needed air for secondary combustion. Figure 41

NOTE: Do not exceed one (1) layer of rock wool coverage.

Top Left

Log #4

Left Base

Log #2

Pins

Top Mid Log #6

Top Right

Log #5

Right Base

Log 33

Rear Log #1

REMOTE CONTROL

PILOT

LG819

OFF

Rock Wool

Figure 41 -

Place CSDV40 Rock Wool

REMOTE CO

NTROL

PILOT

Figure 40 -

Place CSDV40 Logs

OFF

LG818

Pins

28 58D6056