Monessen Hearth CSDV40SLP, CSDV40NDV manual PLACE CSDV30 LOGS IN FIREBOX, Log Placement, 58D6056

LOG PLACEMENT CSDV Series Direct Vent Gas Stove

PLACE CSDV30 LOGS IN FIREBOX

Figure 38

1.Carefully remove logs from wrapping.

2.Open front door of firebox.

3.Place rear log (#1) on rear log pin.

4.Place left base log (#2) on the two pins against left side of firebox.

5.Place right base log (#3) on the two pins against right side of firebox.

6.Place top left log (#4) on left base log. Line up the notch in the bottom of the top log with the locator pins on the bottom log.

7.Place top right log (#5) on right base log. Line up the notch in the bottom of the top log with the locator pins on the bottom log.

Top Left Log #4

Top Right Log #5

Left Base

Log #2

place logs and rock wool (ember material) in firebox

Break up rock wool (ember material) into dime-sized pieces. Fluff up rock wool. Place rock wool evenly across the front of the burner surface. Do not block any areas around the perimeter of the burner, as these are the areas that supply the needed air for secondary combustion. Do not cover the screen on the rear half of the burner as this area allows for air to enter under the front logs. Do not place rock wool under logs. Figure 39

NOTE: Do not exceed one (1) layer of rock wool overage. Do not place rock wool on rear of burner.

Right Base Log #3

REMOTE CONTROL

PILOT

OFF

Rear Log #1

Rock Wool

Figure 39 -

LG817

Pins

Place CSDV30 Rock Wool

REMOTE	CON	TROL
		PILOT

Figure 38 -
Place CSDV30 Logs	OFF

LG816

Pins

58D6056 27