How do I replace the spark ignitor battery?

To replace the spark ignitor battery, simply remove the old battery and insert a new one.

Why won't the pilot stay lit?

The pilot may not stay lit due to a defective thermocouple, air in the gas line, or no gas supply. Check and address these issues accordingly.

It is normal for the flames to appear blue during start up. They will gradually turn yellow as the appliance heats up.

CSDV Series Direct Vent Gas Stove

WARNING

Turn appliance OFF and allow to cool before servicing. Only a qualified service person should service and repair the heater.

NOTE: All troubleshooting items are listed in order of operation.

OBSERVED PROBLEM		POSSIBLE CAUSE		REMEDY
Spark ignitor will not light the	1.	Battery needs replacing	1.	Replace battery
pilot after repeated pressing of	2.	Defective ignitor	2.	Check connections to ignitor. Replace
spark ignitor.				ignitor if ignitor connections are good,
				but there is no spark.
	3.	Misaligned spark electrode	3.	Check for spark arcing from the electrode
				to pilot. Adjust by loosening screws on
				pilot base. Adjust and retighten.
Pilot will not stay lit.	1.	Defective thermocouple. Loose	1.	Check for proper connection of
		thermocouple.		thermocouple to rear of valve.
	2.	Air in gas line	2.	Bleed line. Contact dealer.
	3.	No gas	3.	Check shutoff valve and gas supply
				(LPG tank)
Burner will not light when	1.	Defective switch	1.	Check switch connections. Jump wires
valve and burner switch are				at switch
both on.	2.	Defective thermopile	2.	Check connections to valve. Contact
				dealer.
	3.	Thermostat set too low/defec-	3.	Turn up thermostat to start unit. check
		tive		thermostat connections.
Glass fogs up	1.	Normal condition	1.	Allow appliance to warm up. Glass will
				clear. Additives in the gas may dirty
				glass. Clean glass when cool.
Blue flames	1.	Normal during start up	1.	Flames will yellow as appliance heats
				up.
Sooting	1.	Flame impingement	1.	Check log position. Open shutters to
				increase primary air.

58D6056