CSDV Series Direct Vent Gas Stove
Vent Opening for Combustible Walls
9Z\x"
(241 mm)
9Z\x"
(241 mm)
Framing Detail
Vent Opening for Noncombustible Wall
7Z\x"
(190 mm)
Figure 17 - |
|
Locate Vent Opening on Wall | |
|
Apply Mastic to
All Four Sides
| HOT |
FP1955 |
|
Vent Cap | Wood Screw |
Figure 18 - |
|
Install Horizontal Vent Cap
Cut Vinyl Siding
Away to Fit Standoff
Apply Mastic to
All Four Sides
Standoff
Vent
Cap
FP1956 |
| HOT |
|
| |
| Nut | Bolt |
|
|
Wood
Figure 19 -Screw
Install Vinyl Siding Standoff
Venting installation
| WARNING | Do not recess vent termination into any |
|
| |
|
| wall. |
|
| This will cause a fire hazard. |
|
|
|
5.Slide the wall thimble over the vent pipe before con- necting the horizontal run to the vent cap. Figure 20
6.Carefully move the stove with vent assembly attached toward the wall and insert the vent pipe into the hori- zontal termination. The pipe overlap should be a mini- mum of 1Z\v" (32 mm). Apply silicone to the outer pipe connection. Fasten all vent connections with screws provided.
7.Slide the wall thimble against the interior wall surface and attach with screws. Figure 20
Interior Wall
Surface
Vent Cap (Horizontal
Termination)
Decorative
Wall Thimble
FP1957 |
|
| |
Figure 20 - | Screw | Horizontal | |
Connect Vent Cap with | Vent Pipe | ||
| |||
Horizontal Vent Pipe |
|
|
Horizontal termination configuration examples
Figures 21 through 23 show different configurations for venting and horizontal termination. Each figure includes a chart with an example of horizontal maximum and vertical minimum dimensions taken from the chart on Page 14. NOTE: The horizontal run controls the mini - mum vertical height (i.e. the longer the hori - zontal run, the higher the termination will be). Follow the chart on Page 14. All horizontal terminations require a 1/4" (6 mm) rise per 12" (305 mm) of horizontal run.
16 | 58D6056 |
