Installation B
High-Definition DVR DCX3510-M • Installation Manual 13
365-095-17066-x.1
Before you move or change components on the subscriber’s ent ertainment system:
• Review the installation instructions.
• Determine if you are connecting the set-top to the TV by the composite (baseband)
video input or a High-Definition video input (component video, H DMI, or IEEE-1394).
• Determine if the subscriber has other equipment to be connec ted to the terminal
(home theater or A/V receiver, VCR, etc.).
• Verify that you have the necessary cables and other require d items.
• If the terminal was previously used, clear its hard drive bef ore installing it at a new
subscriber location.
Cold Reset Procedure
This section describes the Cold Reset procedure for Motorola’s DCX3510-M set-top.
The cold reset is generally used by operational and field pers onnel to accomplish the
following:
• Restore the set-top to a known state.
• Clear channel maps and application settings.
• Remove application and software objects above the pla tform code.
• Clear the Out of Band (OOB) Last Known Carrier (LKC) and f orce the units to hunt for
a new OOB control channel.
Remote Control Cold Reset
1. Remove the set-top from its packaging.
2. Apply AC power to the set-top.
3. Point the remote control at the set-top and press the SELECT key.
The POWER LED on the front panel begins to flash slowly.
4. Release the SELECT key.
5. Within 2 seconds, press the 3 key on the remote control.
The POWER LED flashes quickly.
6. Within 2 seconds, press the 2 key on the remote control.
The POWER LED will flash slowly.
7. Within 2 seconds, press the 8 key on the remote control.
The POWER and MESSAGE LEDs flash two times, and the set-top performs a c old
reset operation.
3