Level 1 and 2 Service Manual

Disassembly

Removing and Replacing the Rear Housing

1.Remove the battery cover, battery, as described in the procedures.

2.Using a Torx® driver with a T-6 bit, remove the 6 screws from the rear housing (see Figure 7).

3.Carefully separate the rear housing from the front housing by starting at the top and lifting the rear housing up and away from the front housing to remove.

Lift Rear Housing

Up and Off Front

Housing

Rear Housing

Screw LocationsFigure 7. Removing and Replacing the Rear Housing

4.To replace, insert the bottom of the rear housing into the front housing and gently press together.

5.Insert and torque the 6 screws to 2.6 in. pounds.

6.Replace the battery, and battery cover as described in the procedures.

Removing and Replacing the Transceiver PC Board

1.Remove the battery cover, battery, and rear housing as described in the procedures.

GThis product contains static-sensitive devices. Use anti-static handling procedures to prevent ESD and component damage.

2.Insert the flat end of the disassembly tool between the front housing and the transceiver PC board as shown in Figure 8.

6809480A37-O

April 21, 2004

21