Section 2
Installation
NOTE
You will not install the front plate of the repeater housing until you have completed all tests and adjustments under the heading Tests and Adjustments.
Initial
The following steps describe the process of turning on the ZR310 for the first time.
1.Remove protective covers from both radios LED displays
2.Connect the power cable into a 115/230Vac power source
NOTE
The "115/230" switch on the bottom of the power supply must be in the position corresponding to the power source. You should have done this during the GR300 basic assembly.
3. Turn on the power supply. The unit is on when the red portion of the switch is visible.
4.Turn on both radios by rotating the volume controls clockwise.
5.Verify that the ZR310 green Power LED is illuminated, the display windows on both radios are illuminated and the fan is operating.
Diagnostic Commands - Refer to Programming Section, Diagnostic Commands.
Programming - To customize the ZR310 to your particular application, refer to the Programming section.
March, 1993 |
| Section |