BATTERIES
|
|
| Accessories |
| MOTOROLA BATTERIES | ||
|
| ||
|
|
|
|
Kit Number | Description/Chemistry | Charging Time* |
|
|
|
|
|
NTN8618A | 2.5 Hours |
| |
|
|
|
|
NTN8615A | Slim Lithium Ion | 2.5 Hours |
|
|
|
|
|
NTN8614A | Standard Lithium Ion | 3 Hours |
|
|
|
|
|
NTN8617A | Extended Lithium Ion | 4 Hours |
|
|
|
|
|
*Charging times based on a
N O T E :
•It is recommended to charge the batteries within the temperature range of 10°C to 40°C (50°F to 104°F).
•Prolonged charging is not recommended. Typical charging guidelines are shown in the above table.
Charging Lithium Ion Batteries
The following are approximate charge times to 90% capacity using Motorola iDEN Approved Lithium Ion battery Chargers. For optimal battery life, use a Motorola iDEN Approved Lithium Ion charger with your Motorola iDEN Lithium Ion battery. Other chargers may not fully charge your Lithium Ion battery or may yield a reduced number of cycles.
Battery Operating Instructions
•Battery performance will degrade at extreme temperatures.
Do not store your battery where temperatures will exceed 60°C (140°F) or fall below
•This Lithium Ion battery has a self discharge rate and without use, will lose about 1% of its charge per day.
•The battery capacity will degrade if stored for long periods while fully charged. If long term storage is required, store at half capacity.
•The Motorola iDEN Approved Lithium Ion chargers will provide optimum performance. Other chargers may not fully charge your iDEN Lithium Ion battery or may yield reduced number of charge cycles.
•Charger lights on Motorola iDEN chargers may flash or extinguish during normal charger use.
•If the battery appears inoperative, the internal protection circuitry may have been activated. Remove the battery from the portable and put it into the charger for several minutes to reset the circuitry.
i1000
GETTING STARTED 59
