RS-232 Interface 7 - 17

RTS Line State

This parameter sets the idle state o f the Serial Host RTS line. Scan a bar code belo w to select Low RTS or High
RTS line state.
*Host: Low RTS
Host: High RTS

Beep on <BEL>

Point-to-Point Mode Only
When this parameter is enabled, the scanner issues a beep when a <BEL> character is detected on the RS-232
serial line. <BEL> is issued to indicate an illegal entry or other important event.
Beep On <BEL> Character
(Enable)
*Do Not Beep On <BEL> Character
(Disable)
NOTE This parameter is not supported in Multipoint-to-Point Mode.