1 - 8 Symbol LS3578 Product Reference Guide
Removing the Battery
To remove the battery:
1. Insert a coin or flathead screwdriver in the slot at the base of the scanner, then turn the slot counterclockwise
to release the latch.
2. Lift the latch.
3. Turn the scanner upright to slide the battery out.
Charging the Scanner Battery in the Cradle
For best performance, fully charge the scanner battery before using the scanner for the first time. To charge the
scanner battery, place the scanner in the cra dle (see Inserting the Scanner in the Cr adle on pa ge 1- 9). The battery
begins charging when the scanner LED indicator starts flashing green. A complete charge of a fully discharged
battery can take up to four hours using external power and up to 10 hours using the interface cable.
Charge within the recommended temperature of 32° to 104° F (0° to 40° C) nominal, 41° to 95° F (5° to 35° C)
ideal.
For information on maximizing battery life, see Battery Maintenance on page 3-1.
Scanner Charging LED
The scanner’s green LED indicates charging activity (see Table 2-2 on page 2-4). If the scanner is chargin g in fast
mode (non-bus powered mode), the green LED blinks at a fast rate. If the scanner is charging in slow mode
(bus-powered mode), the LED blinks at a slow rate.
If the scanner’s red LED begins flashing, indicating a charging problem, remove the scanner from the cra dle and
replace the battery. If the red LED continues flashing, contact Motorola Enterprise Mobility Support.