MSI 848P NEO-V - Motherboard - ATX manual Dual-channel DDR Introduction, Installing DDR Modules

MS-6788 ATX Mainboard

Dual-channel DDR Introduction

Please note that each DIMM can work respectively for single-channel DDR, but there are some rules while using dual-channel DDR (Please refer to the suggested DDR population table below). Inserting your memory modules in the memory slot with different color will work as dual-channel DDR. Users may install memory modules of different type and density on different-channel DDR DIMMs. However, the same type and density memory modules are necessary while using dual-channel DDR, or unstability may happen.

Please refer to the following table for detailed dual-channel DDR only for 865PE Neo2-V. Other combination not listed below will function as single-channel DDR.

DIMM1 (Ch A) DIMM2 (Ch A)	DIMM3 (Ch B)	System Density
128MB~1GB	128MB~1GB	256MB~2GB

MSI Reminds You...

Dual-channel DDR for 865PE Neo2-V works ONLY in the DIMM1-DIMM3 combination listed in the table above.

Installing DDR Modules

1.The DDR DIMM has only one notch on the center of module. The module will only fit in the right orientation.

2.Insert the DIMM memory module vertically into the DIMM slot. Then push it in until the golden finger on the memory module is deeply inserted in the socket.

MSI Reminds You...

You can barely see the golden finger if the module is properly inserted in the socket.

3.The plastic clip at each side of the DIMM slot will automatically close.

Volt Notch

2 - 8