Hardware Setup
ATA100 Hard Disk Connectors: IDE1 & IDE2
The mainboard has a
IDE2 |
IDE1 |
IDE1 (Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1 can connect a Master and a Slave drive. You must configure second hard drive to Slave mode by setting the jumper accordingly.
IDE2 (Secondary IDE Connector)
IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. Refer to the hard disk docu- mentation supplied by hard disk vendors for jumper setting instructions.
Front USB Connectors: JUSB2 & JUSB3
The mainboard provides two USB 2.0 pin headers JUSB2 & JUSB3 that are compliant with Intel® I/O Connectivity Design Guide. USB 2.0 technology increases data transfer rate up to a maximum throughput of 480Mbps, which is 40 times faster than USB 1.1, and is ideal for connecting
JUSB2 & JUSB3 Pin Definition
2 |
|
|
|
|
|
| 10 | PIN | SIGNAL | PIN | SIGNAL |
|
|
|
|
|
| ||||||
|
|
|
|
|
| 1 | VCC | 2 | VCC | ||
1 |
|
|
|
|
|
| 9 | 3 | USB0- | 4 | USB1- |
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||||
JUSB2 / JUSB3 |
| ||||||||||
| 5 | USB0+ | 6 | USB1+ | |||||||
|
|
|
|
|
|
|
| 7 | GND | 8 | GND |
|
|
|
|
|
|
|
| 9 | Key (no pin) | 10 | USBOC |
|
|
|
|
|
|
|
|
|
|
|
|
