BIOS Setup
Integrated Peripherals
Please note that the options showed on your BIOS might be different de- pending on the motherboard you buy.
USB Controller
This setting is used to enable/disable the onboard USB controllers. Setting options: [Disabled], [Enabled].
USB Device Legacy Support
Set to [Enabled] if your need to use any USB 1.1/2.0 device in the operating system that does not support or have any USB 1.1/2.0 driver installed, such as DOS and SCO Unix. Set to [Disabled] only if you want to use any USB device other than the USB mouse. Setting options: [Disabled], [Enabled].
On-Chip IDE Configuration
Press <Enter> to enter the
On-Chip ATA(s) Operate Mode
This setting allows you to determine how the RAID controller on the south bridge is going to switch to SATA controller. [Legacy Mode] means you may use the traditional 14 and 15 IRQs, while [Native Mode] means you may use all the available IRQs. Setting options: [Legacy Mode], [Native Mode].
