MAINTENANCE INSTRUCTIONS
5.Wind the line onto the spool by turning the spool. The line should go on in the direction of the arrow (A) on the spool (Fig. 20). Line should be wrapped tightly around the spool. The line is wound with each half separated by the divider. Tightly wind it until there is about 6" of line left (Fig. 21).
6.Lock the ends of the line in opposite slots on the spool (Fig. 22). Place the clear plastic line retainer back over the line and spool (Fig. 23). Pull the lower line up into the lower slot in the clear plastic line retainer (Fig. 24). Pull the upper line down into the upper slot (Fig. 25).
7.Insert the line through each eyelet in the spool carrier and slide the spool into the carrier. (Fig. 26)
NOTE: Ensure that the line is within the clear plastic line retainer. If it's outside of the clear plastic line retainer, the line will not feed.
A
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Fig. 24
Fig. 25
Fig. 26
11
