Multi-Tech Systems MT5634ZPW-PCI DS= n Dial Stored Telephone Number, Echo Command Mode Characters

3 AT Commands, S-Registers and Result Codes

		S	Dial a telephone number previously stored using
			the &Zn=x command (see &Zn=x command for
			further information). The range of n is 0-3.
		,	Pause during dialing for time set in register S8.
		;	Return to command mode after dialing. (Place at
			end of dial string.)
		!	Hook flash. Causes the modem to go on-hook for
			one-half second, then off-hook again.
		@ Wait for quiet answer. Causes modem to wait for a
			ringback, then 5 seconds of silence, before
			processing next part of command. If silence is not
			detected, the modem returns a NO ANSWER code.
		$	AT&T's "call card" tones detection.
		^	Disable data calling tone transmission.
Command:	DS=n	Dial Stored Telephone Number
Values:		n = 0–3
Default:		none
Description:		Dial a number previously stored in directory number n
		by the &Zn=x command .
		Example: ATDS=3
Command:	En	Echo Command Mode Characters
Values:		n = 0 or 1
Default:		1
Description:	E0	Do not echo keyboard input to the terminal.
	E1	Do echo keyboard input to the terminal.
Command:	Fn	Echo Online Data Characters
Values:		n = 1
Default:		1
Description:	F0	Enable online data character echo. (Not supported.)
	F1	Disable online data character echo (included for
		backward compatibility with some software).
Command:	Hn	Hook Control
Values:		n = 0 or 1
Default:		0
Description:	H0	Go on-hook to hang up.
	H1	Go off-hook to make the phone line busy.

MT5634ZPW-PCI 39