Multi-Tech Systems MT5634ZPW-PCI owner manual Information Request, Monitor Speaker Volume

Owner’s Manual

Command:	In	Information Request
Values:		n = 0–4, 9, 11
Default:		None
Description:	I0	Display default speed and controller firmware version.
	I1	Calculate and display ROM checksum (e.g., “12AB”).
	I2	Check ROM and verify the checksum, displaying OK
		or ERROR.
	I3	Display default speed and controller firmware version.
	I4	Display firmware version for data pump (e.g., “94”).
	I9	Display country code (e.g., “NA Ver. 1”).
	I11	Display Diagnostic Information for the last Modem
		Connection (i.e., DSP and Firmware version, Link
		Type, Line Speed, Serial Speed, Type of Error
		Correction/Data Compression, Number of past
		Retrains,etc.)

Command:	Ln	Monitor Speaker Volume
Values:		n = 0, 1, 2, or 3
Default:		2
Description:	L0	Select low volume.
	L1	Select low volume.
	L2	Select medium volume.
	L3	Select high volume.

Command:	Mn	Monitor Speaker Mode
Values:		n = 0, 1, 2, or 3
Default:		1
Description:	M0	Speaker always off.
	M1	Speaker on until carrier signal detected.
	M2	Speaker always on when modem is off-hook.
	M3	Speaker on until carrier is detected, except while
		dialing.

Command:	Nn	Modulation Handshake
Values:		n = 0 or 1
Default:		1
Description:	N0	Modem performs handshake only at communication
		standard specified by S37 and the B command.
	N1	Modem begins handshake at communication
		standard specified by S37 and the B command.
		During handshake, fallback to a lower speed can
		occur.

40 MT5634ZPW-PCI