Multi-Tech Systems MT5634ZPW-PCI owner manual Store Current Configuration, Store Telephone Number

3 AT Commands, S-Registers and Result Codes

Command:	&Wn	Store Current Configuration
Values:		n = 0
Default:		None
Description:	&W0	Store active modem settings in NVRAM; load them at
		power-on or following the ATZ command instead of
		loading the factory defaults from ROM.
Command:	&Yn	Select Stored Configuration for Hard Reset
Values:		n = 0
Default:		0
Description:	&Y0	Select stored configuration 0 on power-up. (For
		backward compatibility with some software.)
	&Y1	Not supported—responds ERROR.
Command: &Zn=x		Store Telephone Number
Values:		n = 0, 1, 2, or 3
		x = Dialing string
Default:		None
Description:		Stores telephone dial string x in memory location n.
		Dial the stored number using the command ATDS=n.
Command:	\Gn	Modem Port Flow Control
Values:		n = 0
Default:		0
Description:	\G0	Returns an OK for backward compatibility with some
		software.
	\G1	Not supported—responds ERROR.
Command:	\Jn	Data Buffer Control
Values:		n = 0
Default:		0
Description:	\J0	Enable data buffer—serial port speed is independent
		of connect speed.
	\J1	Not supported—responds ERROR.
Command:	\Kn	Set Break Control
Values:		n = 5
Default:		5
Description:	\K5	Modem sends break signal received from the DTE to
		the remote modem.

MT5634ZPW-PCI 45