Multi-Tech Systems MT5634ZPW-PCI owner manual S10

3 AT Commands, S-Registers and Result Codes

Register	Unit	Range	Default	Description
S6	seconds	2–65*	2*	Sets the time the modem will wait
				after it goes off-hook before it be-
				gins to dial the telephone number.
S7	seconds	1–255*	50*	Sets the time the modem will wait
				for a carrier signal before aborting
				a call. Also sets the wait for si-
				lence time for the @ dial modifier.
S8	seconds	0–65	2	Sets the length of a pause caused
				by a comma character in a dialing
				command.
S10	100 ms	1–254	20	Sets how long a carrier signal
				must be lost before the modem
				disconnects.
S11	1 ms	50–150*	95*	Sets spacing and duration of dial-
				ing tones.
S28	decimal	0, 1–255	1	0 disables, 1–255 enables V.34
				modulation.
S30	1 minute	0–255	0	S30 specifies the length of time (in
				minutes) that the modem waits
				before disconnecting when no
				data is sent or received. This
				function is only applicable to
				buffer mode. (Also see \T com-
				mand.)
S35	decimal	0–1	0	0 disables, 1 enables the V.25 data
				calling tone, which allows remote
				data/fax/voice discrimination.
S36	decimal	{0,2}, {1,3} N/A		This register specifies the action
				to take in the event of negotiation
		{4,6}, {5,7}		failure when error control is se-
				lected. (See S48.)

MT5634ZPW-PCI 49