Multi-Tech Systems MT5634ZPX-PCI-V92 manual Command +VCID=n Caller ID Selection

MultiModemZPX User Guide		4 AT Commands, S-Registers, and Result Codes
Command: +VCID=n Caller ID Selection
Values:		n = 0, 1, or 2
Default:		0
Description:		Enables Caller ID detection and configures the reporting and
		presentation of the Caller ID data that is detected after the first
		ring. The reported data includes the date and time of the call,
		the caller's name and number, and a message. Set S0=2.
+VCID=0		Disables Caller ID
+VCID=1		Enables Caller ID with formatted data
+VCID=2		Enables Caller ID with unformatted data
+VCID=?		Displays the allowed values
+VCID?		Displays the currrent value
Command: +VDR=x, y Distinctive Ring Report
Values:		x = 0, 1 Distinctive Ring report control. See description.
		y = 0–255Minimum ring interval in 100 ms units. See description.
Default:		0, 0
Description:		Enables reporting of ring cadence information to the DTE and
		specifies the minimum ring cadence that will be reported.
		The report format is one line per silence period and one line
		per ring period. The length of the silence period is in the form
		DROF=number in units of 100 ms<CR><LF>, and the length of
		the ring is in the form DRON=number in units of 100 ms<CR>
		<LF>. The modem may produce a Ring event code after the
		DRON message if enabled by the y parameter. The y parameter
		must be set to a value equal to or smaller than the expected
		ring cadence in order to pass the report to the DTE.
+VDR=0, n/a		Disables Distinctive Ring cadence reporting.
+VDR=1, 0		Enables Distinctive Ring cadence reporting. Other call progress
		result codes (including RING) are reported as normal.
+VDR=1, >0		Enables Distinctive Ring cadence reporting. The RING result
		code is reported after the falling edge of the ring pulse (i.e., after
		the DRON report).
+VDR=?		Displays the allowed values.
+VDR?		Displays the currrent value.
Command:	#Sx	Enter Setup Password
Values:		x= password (1–8 characters, case sensitive)
Default:		MTSMODEM
Description:		Enters the remote configuration setup password.
Command:	#S=x	Store Setup Password
Values:		x= password (1–8 characters, case sensitive)
Default:		MTSMODEM
Description:		Stores a new remote configuration setup password.

38