MultiModemZPX User Guide | 4 AT Commands, | |
Command: | &Sn | Data Set Ready (DSR) Control |
Values: |
| n = 0 or 1 |
Default: |
| 0 |
Description: | &S0 | DSR is always high (on). |
| &S1 | DSR goes high only during a connection. |
Command: | &Tn | V.54 Test Commands |
Values: |
| n = 0, 1, 3 or 6 |
Default: |
| None |
Description: | &T0 | Abort. Stops any test in progress. |
| &T1 | Initiates local analog loopback test. |
| &T3 | Initiates local digital loopback test. |
| &T6 | Initiates remote digital loopback test. |
Note: To stop a test, you must use the escape sequence (+++AT) before typing &T0.
Command: | &V | Display Current Settings |
Values: |
| n/a |
Description: |
| Displays the active modem settings. |
Command: | &Wn | Store Current Configuration |
Values: |
| n = 0, 1 |
Default: |
| None |
Description: | &W0 | Stores current modem settings in nonvolatile memory and |
|
| causes them to be loaded in place of the factory defaults at |
|
| |
|
| command. |
| &W1 | Clears user default settings from nonvolatile memory and |
|
| causes the factory defaults to be loaded at |
|
| ing the ATZ command. |
Command: &Zn=x | Store Dialing Command | |
Values: |
| n = 0, 1 |
|
| x = Dialing command string |
Default: |
| None |
Description: |
| Stores dialing command x in memory location y. Dial the |
|
| stored number using the command ATDS=n. |
Command: | &&S | Speaker Codec Loopback |
Values: |
| n/a |
Description: |
| Provides a loopback from the microphone to the speaker. For |
|
| testing and debugging only. |
Command: | \An | Select Maximum MNP Block Size |
Values: |
| n = 0, 1, 2, or 3 |
Default: |
| 3 |
Description: | \A0 | |
| \A1 | |
| \A2 | |
| \A3 |
28